Impact Tester NOVOTEST STRIKE U1-4219 digunakan untuk menguji kekuatan pelapisan saat terjadi benturan pada pipa selama proses instalasi dan pengoperasian. NOVOTEST STRIKE U1-4219 memungkinkan pengujian langsung pada pipa tanpa perlu membuat sampel terlebih dahulu.
Menurut standar yang berlaku, direkomendasikan untuk menguji kekuatan pelapisan setelah terjadi benturan bersamaan dengan memeriksa kontinuitas pelapisan setelah benturan menggunakan Pulse Holiday Detector NOVOTEST SPARK-1.
Keuntungan Pipe Impact Tester NOVOTEST STRIKE U1-4219 :
Alat ini dipasang pada tiga kaki sekrup yang dapat diatur, sehingga STRIKE U1-4219 dapat dipasang di permukaan datar (saat menguji sampel) atau langsung pada pipa berdiameter apa pun.
Alat pengujian dampak ini terbuat dari baja struktural dan dilapisi cat bubuk, yang menjamin daya tahan dan kemampuannya beroperasi di kondisi lapangan yang sulit.
Spesifikasi
Operating
Operating method
The tests can be performed in two ways:
- By principle destroyed / not destroyed, when the test is performed at set up height and a certain weight of sinker (test coating for compliance with the specific requirements)
- Test for define the minimum drop height with a gradual increasing the height of the falling and the minimum weight of sinker at which the coating was cracked or exfoliated from the painted surface
Testing
Install the required sinker at the desired height. If necessary, use required restrictors to limit the depth of the indentation. Put the tested plate outside (direct hit) or inside (back side hit) on the anvil cover. Holding the tested plate at this position by a presser coupling. Release the sinker and allows it to fall on the tested plate, which is lying on the anvil. After that inspect the coating with the magnifying glass.
General specifications of the Impact Tester NOVOTEST STRIKE U1-4219
| Compliance with standards | DSTU 4219, GOST 51164 |
| Weight | 10 kg |
| Instrument scale length | 500 mm |
| Graduation | 10 mm |
| Ball diameter | 16 mm |
Opsional Produk
It is possible to manufacture the device with any other values of the diameters of the balls, the mass of the load and the length of the scale of the device. Specify the required parameters when placing an order in the basket.
Reviews
There are no reviews yet.